Intermec Trakker Antares 2410 User Manual page 2

maximum amount of time to charge a fully discharged battery. It
may take less time depending on the state of the battery charge.
Battery Pack Charging Times
Battery Pack
1350 mAh single-cell (P/N 069428)
2700 mAh dual-cell (P/N 069429)
2400 mAh single-cell (P/N 073929)
4800 mAh dual-cell (P/N 073930)
Loading and Unloading a Battery Pack Into the Charger
Align the battery pack
with a battery slot on
the charger (as shown
in the illustration) and
slide the battery pack
down until it fits
Status
LEDs
firmly in the charger.
To unload a battery
pack from the charger,
simply pull it out of
the battery slot. You
can unload and use a
battery pack before it
has been fully charged.
Interpreting the Status LEDs
Each battery slot has two status LEDs that indicate the status of the
battery pack in the slot.
Status LED Descriptions
Status LED Description
Yellow The battery pack is charging or cold.
Green The battery pack is fully charged or over heated.
Off The battery slot is empty or the charger is not plugged in.
Flashing Yellow There has been a charge interrupt or timeout.
Charging Time
1.25 hours
2.5 hours
5 hours
9 hours
Battery
slot
Power supply
jack
241XI003.eps
Important Recommendations
• Use only Intermec-labeled lithium-ion battery packs (P/N 069428,
P/N 069429, P/N 073929, or P/N 073930) in the battery charger.
• Charge the battery pack immediately before use or within a couple
of days of use.
• For maximum battery efficiency, the recommended temperature
range when charging is 25°C (77°F).
• While the charger is in use, it becomes warm. This is normal.
• Remove the battery pack from the charger within 24 hours after
charging is completed.
• Keep the battery and charger contacts clean and free of dust and
dirt. Remove any accumulated debris using a non-metallic pointed
object.
• Do not let anything metallic come into contact with the battery
charger contacts.
• Do not disassemble the charger. There are no user-serviceable parts
in the charger.
• Do not place the charger in locations that are extremely hot or
cold, dusty or dirty, very humid, or subject to vibration.
• If any part of the charger appears worn or damaged, or if any
difficulty arises while using the battery charger, unplug the battery
charger immediately and contact your Intermec service
representative.
Troubleshooting
If the charger does not charge the battery pack or if the LEDs do not
light, try the following solutions:
• Make sure that the charger is plugged in to an electrical outlet and
that the electrical outlet has power.
• Clean the contacts on the charger and battery pack with a cotton
swab and isopropyl alcohol.