Intermec Janus 2010 Reference Manual page 213

Subsystem 0200 CM (Configuration Management) (continued)
Hex Code Message
8218 Inappropriate configuration for the current protocol
8219 BIOS rejected the set configuration command
821A Configuration command string object is too small
821B Configuration ID is invalid
821C Invalid build parameter
821D No build function
821E No more build entries
821F No more build entries in wedge lookup table
8220 No more build entries in wedge lookup table for "build next" WM command
8221 No entries found in the LUM key table
8222 No match in lookup table for specified character
8223 At least one parameter rejected by client (see JANUS.ERR)
8224 Configuration item is not found
8225 File open error
8226 File write error
8227 File read error
8228 Record too large to be read
8229 Invalid hex character found in the escape sequence
822A Invalid escape sequence
822B Read attempted on a file that was not opened
822C Write attempted on a file that was not opened
822D File close operation failed
822E Attempt made to close a file that is not open
822F Invalid default configuration
8230 RF back is not installed
8231 RF protocol handler is not installed
8232 Path specified by IMPATH is not found
8233 BIOS returned an invalid value during build
8234 Configuration item is not allowed for the selected protocol
Appendix A: Status Codes
A
A-25