Intermec Janus 2010 Reference Manual page 201

Status Codes and Error Messages Listed in Numerical Order (continued)
Hex Code Severity
8301 Error
8302 Error
8303 Error
8304 Error
8305 Error
8306 Error
8402 Error
8403 Error
8404 Error
8405 Error
8406 Error
8407 Error
840D Error
840E Error
840F Error
8410 Error
8411 Error
8412 Error
8413 Error
Subsystem Reader Message and Description
SC Insufficient timers
Not enough timers for the scanner to initialize
SC Insufficient memory
Insufficient memory for the scanner to initialize
SC IPM connect failed
Scanner not connected to power management
SC Invalid Laser Timeout
Invalid laser timeout configuration
SC Counts obj integrity failed
Count object integrity check failed
SC Scanner vector table corrupt
DC Autodiscrim table full
Autodiscrimination table full
DC Insufficient resources for decode
DC Decode init failure
Decode initialization failure due to scanner
DC No scanner
Decode initialization failure - no scanner present
DC Invalid decodes cmd
Invalid decodes command
DC Symbology out of range
Invalid symbology specified
DC Can't decode scan
Unable to decode scan
DC Missing start/stop
Missing start/stop character
DC Too few counts to decode
DC Invalid char
Invalid character found
DC Invalid acceleration
DC Insufficient chars for valid label
Insufficient characters for valid label
DC Invalid check digit
Appendix A: Status Codes
A
A-13