Intermec Janus 2010 Reference Manual page 197

Status Codes and Error Messages Listed in Numerical Order (continued)
Hex Code Severity
8203 Error
8204 Error
8205 Error
8206 Error
8207 Error
8208 Error
8209 Error
820A Error
820B Error
820C Error
820D Error
820E Error
820F Error
8210 Error
8211 Error
8212 Error
8213 Error
8214 Error
Subsystem Reader Message and Description
CM Invalid Param val
Invalid parameter value
CM Invalid Param 1 value
Invalid first parameter value
CM Invalid Code 39 config
Invalid Code 39 configuration (HIBC and no check digit)
CM Invalid param 2 value
Invalid second parameter value
CM Invalid Code 39 config
Invalid Code 39 configuration (HIBC and full ASCII)
CM Invalid Code 39 config
Invalid Code 39 configuration (HIBC and mixed full ASCII)
CM Invalid Param 3 value
Invalid third parameter value
CM Invalid Codabar cfg
Invalid Codabar configuration (ABC and discard start/stop)
CM Protocol not loaded
CM Invalid comm or protcl
Invalid port or protocol specified
CM No end quote
No ending quote found
CM No dbl quote
No double quote (might be missing an opening quote)
CM Invalid parser state
CM Invalid config cmd
Invalid configuration command
CM Client returned err
Client deemed configuration command invalid
CM Invalid beep duration
CM Invalid beep freq
Invalid beep frequency
CM Invalid beep vol
Invalid beep volume
Appendix A: Status Codes
A
A-9