Intermec Janus 2010 Reference Manual page 203

Status Codes and Error Messages Listed in Numerical Order (continued)
Hex Code Severity
8511 Error
8512 Error
8514 Error
8515 Error
8516 Error
851B Error
851F Error
8520 Error
8522 Error
8523 Error
8524 Error
8526 Error
8527 Error
8528 Error
8600 Error
8601 Error
8602 Error
8603 Error
8604 Error
Subsystem Reader Message and Description
RW Unable to allocate memory for input
RW Prot handler not linked
Protocol handler not linked
RW Rdr cmd parsing err on exit accum
Reader command parsing error on exit accumulation
RW Application break detected
RW Invalid Rdr Wedge request
Invalid Reader Wedge request
RW Rdr cmd erroneously parsed
A reader command was incorrectly parsed when Enter was
parsed
RW Label not accepted: App not requesting input
Label not accepted because the scan-ahead is not enabled and the
application is not at an input statement.
RW Link failed, no buffers
Reader Wedge link failed
RW Invalid port value for input request
Invalid port specified in input request
RW Xmit buffer busy or Comm Utility err returned
Communications error
RW Exit Accum with Comms Error
Communications error from an exit accumulation command
RW Invalid option in RW_DO
Invalid port specified in input request
RW No label symbology, no label input yet
No symbology code available
RW Bad parameter
CU Invalid config
Invalid configuration
CU Buffer length 0 error
CU Comm port in use
CU Protocol error
CU Comm port error
Appendix A: Status Codes
A
A-15