Intermec Janus 2010 Reference Manual page 199

Status Codes and Error Messages Listed in Numerical Order (continued)
Hex Code Severity
8226 Error
8227 Error
8228 Error
8229 Error
822A Error
822B Error
822C Error
822D Error
822E Error
822F Error
8230 Error
8231 Error
8232 Error
8233 Error
8234 Error
8235 Error
8236 Error
Subsystem Reader Message and Description
CM File Write err
File write error
CM File Read err
File read error
CM Read record too large
Record too large to read
CM Invalid Hex Char in esc seq
Invalid hex character found in the escape sequence
CM Invalid esc sequence
Invalid escape sequence
CM Read file not opened
Read attempted on a file that was not opened
CM Write file not opened
Write attempted on a file that was not opened
CM File close op fail
File close operation failed
CM Attempt close non-open file
Attempt made to close a file that was not opened
CM Invalid default config
Invalid default configuration
CM RF back not installd
RF back is not installed
CM RF driver not installd
RF protocol handler is not installed
CM Path (IMPATH) not found
Path specified by IMPATH is not found
CM Bld BIOS val out of range
BIOS returned an invalid value during build
CM Config Item not allowed by Prot
Configuration item is not allowed for the selected protocol
CM Config Item value out of range
Configuration item value is out of range for the selected protocol
CM Invalid 4th param value
Invalid fourth parameter value
Appendix A: Status Codes
A
A-11