Intermec Janus 2010 User Manual page 105

Message
Environment variable
JANUSSIM not found.
File already exists. Replace
existing file?
File name is of improper
type! File not opened.
File: filename Saved.
Number is out of range.
Min = n, Max =n.
Printing Document
Description
You started the Editor, which could
not locate the JANUSSIM
environment variable in your
AUTOEXEC.BAT file.
You specified an existing file during
the Save As operation.
You tried to open an INI file that is
not the correct type, or you specified
the wrong filename.
The Editor has saved the file.
You entered a numeric value that is
out of range for the parameter.
You chose the Print command from
the File menu.
Troubleshooting
Suggested Action
Add this command to your
AUTOEXEC.BAT file:
set janussim= path\
Where path is the drive and directory
where the JANUS Application
Simulator software is installed.
The path must have a terminating
backslash. For example:
set janussim=c:\janussim\
Choose Yes to overwrite the file with
the changes you have made with the
Editor. Choose No to cancel the
operation.
Choose OK. Try to open the file
again, to make sure you typed the
name correctly.
If the problem persists, make sure
the file has the correct file type. You
may have to recreate the file with the
Editor to ensure that it has the
correct file type.
No action required.
Enter a numeric value that is
between the parameter's minimum
and maximum values.
No action required.
5
5-5