Verify The Retrofit; Configure The Cem - ETC sensor+ CEM+ Retro-Fit Manual

V e r i f y t h e R e t r o f i t
Step 1:
Step 2:
Step 3:
Step 4:
C o n f i g u r e t h e C E M +
Step 1:
Step 2:
Step 3:
Step 4:
12
Put the dimmer modules back in the rack in the correct/original order.
Put the CEM+ in the rack.
Power up the rack.
Check that the CEM+ powers up and the rack fan turns on. (The only rack errors
should be a lack of DMX on the ports if the DMX source is not present.)
Configuration of the CEM+ is done via the front face panel interface or via a
graphical HTML interface called Sensor+ Connect that is resident in the CEM+.
Configure the rack to reflect the rack type and dimmer module types installed.
Configure the data types that will be used (DMX and EDMX) including the rack
patch.
For detailed configuration information, please refer to the CEM+ Configuration
Manual.
CEM+ Sensor Rack Retrofit Manual