Table Of Contents - ETC sensor+ CEM+ Retro-Fit Manual

S a f e t y
Please note the following safety warnings before use:
• Disconnect power from the rack(s) before all maintenance.
W A R N I N G :
O v e r v i e w o f t h i s M a n u a l
Reference this manual throughout the retrofit procedure.
• Preparation, page 5
• Remove the Old, page 5
• Control Input Panel Replacement, page 6
the rear of the rack and install the new one.
• Power Termination, page 8
• Data Cabling Preparation, page 8
boards.
• Install the New Backplane & Make Connections, page 9
connect and secure the data cabling.
• Change out the AF Cards (if present)), page 11
Feature cards and install the new ones.
• Finish Up, page 11
• Verify the Retrofit, page 12
• Configure the CEM+, page 12
When viewing this document in electronic form (pdf file) with Adobe Acrobat Reader, blue
italicized text followed by a page number such as
link within the document. If you click on the link, it will jump to that section or topic.
2
RISK OF ELECTRIC SHOCK! Dimmer racks without an accessible power
disconnect device cannot be serviced safely.
- before you open the rack.
- labeling and remove the existing equipment.
- install and secure the power harness adapter cable.
- reinstall the left side of the rack.
- put the dimmers back in the rack and power up the rack.
- remove the existing control input panel from
- install and secure the dimmer data transition
- remove the existing Advanced
- put a configuration in the CEM+.
"Overview of this Manual, page
- install the new backplane and
2" is a
CEM+ Sensor Rack Retrofit Manual