Intermec CN3E Supplementary Manual page 3

Important Radio Information
This module complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that can cause undesired operation.
Caution: Changes or modifications not expressly approved by Intermec could void the user's authority to operate this
equipment.
Attention: Toute modification non expressément approuvée par Intermec risque d'annuler le droit d'utilisation de cet
équipement qui a été accordé à l'utilisateur.
For Users Outside of the United States or Canada
Caution: This marking indicates that the user should read all included documentation before use.
Caution: Use Intermec Model 074246 or AE13 (use with power adapter 851-090-001) for the power supply. Do not
connect and charge the CN3 if the ambient temperature is greater than 40°C (104°F).
Battery Information
Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release toxic
materials if mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Charge only with Intermec Models
AC14, AD10, AD11, AD12, and AV6. Do not short circuit; may cause burns. Keep away from children.
Use only Intermec battery pack Model AB8, AB9, AB15, or AB16. Use of incorrect battery pack may present risk of fire or
explosion. Promptly dispose of used battery pack according to the instructions.
Battery Recycling Information
This product contains or uses a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the
solid waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
L - L -
Specific Absorption Rate (SAR)
Radio Wave Exposure and Specific Absorption Rate (SAR) Information for Model CN3 Configurations with 802.11g Radio
For residents of the European Union and other countries/regions that have adopted the International Commission on Non-Ionizing
Radiation Protection (ICNIRP) SAR limit, the maximum allowed SAR value is 2.0 W/kg over 10 g of tissue. For use at the ear, the highest
SAR value for the Model CN3, as tested by BABT is 0.349 W/kg. For body worn operation, the highest SAR value for the Model CN3, as
tested by BABT, is 0.049 W/kg.
Radio Wave Exposure and Specific Absorption Rate (SAR) Information for Model CN3 Configurations with GSM/GPRS Radio
For residents of the European Union and other countries/regions that have adopted the International Commission on Non-Ionizing
Radiation Protection (ICNIRP) SAR limit, the maximum allowed SAR value is 2.0 W/kg over 10 g of tissue. For use at the ear, the highest
SAR value for the Model CN3, as tested by BABT, is 0.189 W/kg. For body worn operation, the highest SAR value for the Model CN3, as
tested by BABT, is 0.187 W/kg.
This product has been tested and meets the FCC RF exposure guidelines when used with the Intermec accessories supplied or designated for
this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.
Caution: The Intermec Model CN3 requires 24 mm of spacing between the torso and the mobile computer to remain
within the Specific Absorption Rate (SAR) limits for general population exposure. Intermec holster models 815-062-001
and 815-065-001 provide this 24 mm of spacing.
aser and Imager Compliance and Precaution
This product complies with the following standards for laser and LED safety:
• IEC 60825-1 / EN 60825-1 - Class 1 LED Product (imaging options only, no laser label)
Important Radio Information
Intermec Technologies Corporation declares that this module is in compliance with the essential requirements and other relevant provisions
of R&TTE Directive (1999/5/EC).