Full Overlay Panel Installation Instructions - Summit FF1DSS24 User Manual

Full Overlay Panel Installation Instructions

1. To add panels to the FF1DSS24, first remove the stainless steel panel, using the instructions
below:
A. Remove all the screws (4) and washers (3) attaching the stainless steel handle (1) from the
stainless steel drawer panel (2).
B. Remove the screws securing the panel (2) to the brackets (6). There should be four brackets
on the left and right side of the drawer.
C. Carefully set the stainless-steel panel on a soft or padded cloth to avoid damaging the panel.
D. If you are replacing the stainless steel panel with a panel to fit the exact size of the drawer,
remove the brackets (6) and the screws hold them to the drawer (7). Save the brackets and
screws.
2. To add a panel to the drawer, follow the instructions below:
A. Remove any items stored inside the drawers.
Press the right slide release lever down and at
the same time lift the corresponding left slide
lever up, and pull the drawer out until it is free of
tracks and the cabinet. (Fig. 1)
B. Peel off the gasket and remove the handle by
removing the two screws that attach the handle
to the door.
8