Table of Contents
Advertisement
Installing the Anti-Tip Brackets
Included with this unit is a pair of anti-tip brackets to
help prevent the unit from moving inside the
countertop when opening the drawer.
Place the provided brackets in front of the unit's
ventilation grille as shown the figure. Then, secure
the brackets to both walls and the unit using the
included screws.
NOTE: If the unit is installed freestanding, please
place the brackets in front of the unit's ventilation
grille and secure the brackets to the surface it is
being used on by the included screws.
Full Overlay Panel Installation Instructions
These models are designed for field-installed overlay panels. The overlay panels cover the stainless
steel to give a built-in appearance. The overlay panel and appropriate hardware are not included
with the unit and the end user needs to prepare them themselves. Please follow the instructions
below for installation:
The FF1DSS24 model includes a pre-installed
stainless-steel panel, which must be removed
before installing your own custom overlay panel.
Please follow the instructions below:
A. Remove the screws securing the panel (2) to
the brackets (6). There should be four brackets
on the left and right sides of the drawer.
B. Remove all the screws (4) and washers (3)
attaching the stainless-steel handle (1) from the
stainless-steel drawer panel (2).
C. Carefully set the stainless-steel panel on a soft
or padded cloth to avoid damaging the panel.
D. If you are replacing the stainless-steel panel
1
2
3
8
Anti-tip
Screw
Bracket
Screw
Anti-tip
Bracket
4
5
6
7
Advertisement
Table of Contents
