General Information; On Receipt Of The Equipment; Iii.1. Checks; Iii.2. Unpacking - Caladair EVERSKY 500 Installation And Commissioning Manual

II. GENERAL INFORMATION
EVERSKY is a range of high efficiency and low noise emissions decentralised ERU (Energy Recovery Unit). It features as standard an
air CO2 control (DCV).
Installed directly into the room or space to be treated, it avoids the need for a complex and expensive air distribution network.
Featuring a high efficiency static heat exchanger, hot water or electrical coil, fresh air F7 filtration range and reinforced sound
insulation, EVERSKY guarantees expected hygiene and comfort in the case of demanding rooms while limiting energy consumption.
EVERSKY unit features as standard the EASY control with MODBUS or BACNET communication protocols (protocol choice enable on
field). It features an LCD mobile display for easy commissioning and maintenance.
EVERSKY est livrée prêt à fonctionner → système PLUG&PLAY - SET&FORGET. Le paramétrage du régulateur intègre en standard les
différentes options commandées afin de faciliter et minimiser le temps de mise en service.
EVERSKY is delivered as PLUG&PLAY - SET&FORGET: the controller is pre-set and set up with options ordered as standard to facilitate
and minimise commissioning time.
III. ON RECEIPT OF THE EQUIPMENT

III.1. Checks

On receipt of the equipment, check the condition of the packaging and the equipment itself, as well as the number of packages. In
case of damages, make precise reservations on the carrier's delivery note and notify your distributor immediately.

III.2. Unpacking

When unpacking the equipment, check the following points:
o Total number of packages
o Presence of ordered accessories (electrical equipments, sleeves, studs...).
Remove the protective film from the outer shell.
After unpacking the equipment, the waste must be disposed of in accordance with the standards and laws in force and the sorting
rules must be respected.
No packaging should be dispersed in the environment.

III.3. Storage

As long as the appliance is not installed, it must be stored in a dry place. The packaging cannot be considered sufficient for storage
in the weather.
IV. END OF LIFE
Through its membership of the ECO-organization ECOLOGIC, CALADAIR meets the obligations of financing the collection, removal
and treatment of Waste Electrical and Electronic Equipment.
During the installation or uninstallation of this equipment, the user or installer can contact the company Ecologic who will offer him
a collection solution to evacuate the obsolete product in a suitable sector.
Phone: +33 130 577 909
Web : www.e-dechet.com
MS-CDF-019 – Manufacturing Nr: 220001→
EVERSKY
Version B Update: 2022/06/14
™
8/70