Viii.7. Aeraulic Connection; Viii.8. Connecting The Power Supply - Caladair EVERSKY 500 Installation And Commissioning Manual

VIII.7. Aeraulic connection
Step
Loosen the screws (F) and remove the port panels.
1
Flip the port panels and connect them to the ducts.
Tighten the screws (F).
The modularity of the port panels makes it possible to position them on any side according to the diagram below:
2
VIII.8. Connecting the power supply
Provide electrical protection devices (circuit breaker, differential)
upstream the of the power supply cable of the unit. Electrical
characteristics needed for the selection and the sizing of power
supply (cable section, guards...) are available in chapter I.3
Electrical characteristics).
Drill the rubber wire pass (A) or (B) positioned on one of the
faces and run the power cable through it.
One of the wire passes (B) is reserved for the draining of
condensate by gravity.
MS-CDF-019 – Manufacturing Nr: 220001→
EVERSKY
Description
Version B
™
Update: 2022/06/14 18/70