2.0 - ALARM CONTROL DEVICES 3.0 - ALARM OPERATION The 2-button remote control and the override touch key are used to operate the 3.1 - Arming alarm system. Press remote control button 1 or touch the override key to its receptacle to arm the alarm.
Page 4
3.9 - Limiting acoustic signals 3.6 - Motion sensor exclusion Alarm conditions caused by a sensor will trigger a maximum of 8 It is recommended if you are traveling by ferry that the alarm is not armed as consecutive alarm cycles during any armed period. The siren will then be the motion sensor could trigger the alarm system.
Page 5
4.0 - PROGRAMMABLE FEATURES 7.0 - REPLACING REMOTE CONTROL BATTERIES The alarm is factory preset with the following features enabled: If the batteries are running low the status LED will blink at the press of a button. To replace the batteries proceed as follows: Factory settings Feature State...
Need help?
Do you have a question about the SIGS39 and is the answer not in the manual?
Questions and answers