Skil BB9504-00 Owner's Manual page 17

Installing table assembly
(Fig. 4a)
1. Insert the work table index pin into the hole
in the tool's housing.
2. Position the large flat washer over the table
locking knob, then securely tighten the
locking knob by turning it clockwise.
WARNING
between the table and sanding surface, the
table edge should be no more than 1/16"
(1.6 mm) away from sanding surface.
Squaring the work table to the
sanding disc (Fig. 4b & 4c)
1. Using a combination square, check the angle
of the work table with the sanding belt.
2. If the work table is not 90° to the disc, loosen
the table locking knob and tilt the table.
3. Adjust the work table until it is perpendicular
to the sanding disc and retighten the locking
knob.
Note: The bevel pointer should point at 0
on the bevel scale after squaring (Fig. 4c).
If not, contact an Authorized SKIL Service
Station for assistance.
To avoid trapping the
workpiece or fingers
Fig. 4a
Index pin
Large flat washer
Fig. 4b
Table locking knob
Fig. 4c
Bevel scale
Tighten
Table locking knob
Combination square
Bevel pointer
17