Assembly And Adjustments - Skil BB9504-00 Owner's Manual

ASSEMBLY AND ADJUSTMENTS

Tools needed for assembly and adjustment
WARNING
6mm Hex Wrench
(included)
WARNING
Installing sanding disc and guard
(Fig. 2 & 3)
1. Remove the backing from the sanding disc.
Align the perimeter of the disc with the
sanding plate and press the disc firmly into
position all the way around (Fig. 2).
2. Locate the disc guard and two Phillips
screws.
3. Position the disc guard against the guard
mounting holes.
4. Using a Phillips screwdriver (not included),
tighten the Phillips screws (ST4.2X10)
securely, applying light pressure to thread
the holes (Fig. 3).
WARNING
only.
16
Disconnect the plug from the power source before performing any
assembly, adjustment or repair to avoid possible injury.
Phillips Screwdriver
(not included)
To reduce the risk of injury, never connect plug to power source outlet until
all assembly steps are completed.
To avoid injury, use
6" (150 mm) abrasive discs
Combination Square
(not included)
Fig. 2
Sanding plate
Fig. 3
Phillips screw
Disc guard
Sanding disc