Skil BB9504-00 Owner's Manual page 4

When not in use, before servicing, when changing blades, bits, cutters, etc.
REDUCE THE RISK OF UNINTENTIONAL STARTING
Make sure the switch is in the "OFF" position before plugging in tool.
GROUND ALL TOOLS
This tool is equipped with an approved 3-conductor cord and a 3-prong grounding type plug
to fit the proper grounding type receptacle. The green conductor in the cord is the grounding
wire. Never connect the green wire to a live terminal.
NEVER STAND ON TOOL OR ITS STAND
Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted. Do
not store materials on or near the tool such that it is necessary to stand on the tool or its stand
to reach them.
CHECK DAMAGED PARTS
Before further use of the tool, a guard or other part that is damaged should be carefully
checked to ensure that it will operate properly and perform its intended function. Check for
alignment of moving parts, mounting, and any other conditions that may affect its operation. A
guard or other part that is damaged should be properly replaced.
WARNING
Service Stat ion or other competent repair service.
WARNING
WARNING
recommended can result in serious personal injury.
4
All repairs, electrical or mechanical, should be attempted only by trained
repairmen. Contact the nearest SKIL Factory Service Center, Authorized
Use only SKIL replacement parts; any others may create a hazard.
Do not use any attachments or accessories not recommended by the
manufacturer of this tool. The use of attachments or accessories not