Exmark 116-8431 Operator's Manual page 9

1. 5/16-18 x 2 1/4 inch
screw
2. 5/16 nyloc nut
3. Cable bracket
4. #10 nyloc nut
5. Shim
7. Remove the 5/16-18 x 2 1/4 inch screw and nut
from cable bracket assembly. Install the cable
bracket assembly onto the LH frame close to the
foot pedal and reinstall the carriage bolt and nyloc
nut (reference Figure 8).
8. Insert the cable control pivot into the foot pedal
and secure with hairpin.
9. Route the cable along the LH frame and around
the backside of the cross shaft. Secure the cable
to the cross shaft with two velcro straps.
Figure 7
6. Cable
7. Clamp
8. #10-24 x 1/2 screw
9. Cable control pivot
g020094
1. Foot pedal
2. Cable bracket
3. Cable
9
Setup
Figure 8
4. Cross shaft
5. Velcro strap
g020092