Download Print this page
Exmark 116-9360 Installation Instructions
Exmark 116-9360 Installation Instructions

Exmark 116-9360 Installation Instructions

Mule drive damper retrofit kit

Advertisement

Quick Links

Mule Drive Damper Retrofit Kit
Kit No. 116-9360
For Serial No. 600,000–312,999,999
This product contains a chemical or chemicals known to the State of California to
Safety Alert Symbol
This Safety Alert Symbol (Figure 1) is used both in this
instruction sheet and on the machine to identify important
safety messages which must be followed to avoid accidents
This symbol means: ATTENTION! BECOME ALERT!
YOUR SAFETY IS INVOLVED!
Safety Alert Symbol
The safety alert symbol appears above information which
alerts you to unsafe actions or situations and will be followed
by the word DANGER, WARNING, or CAUTION.
DANGER: White lettering / Red background. Indicates an
imminently hazardous situation which, if not avoided, Will
result in death or serious injury.
WARNING: Black lettering / Orange background. Indicates
a potentially hazardous situation which, if not avoided, Could
result in death or serious injury.
CAUTION: Black lettering / Yellow background. Indicates
a potentially hazardous situation which, if not avoided, May
result in minor or moderate injury.
This manual uses two other words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
© 2012—Exmark Mfg. Co., Inc.
Industrial Park Box 808
Beatrice, NE 68310
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Figure 1
www.Exmark.com
WARNING
CALIFORNIA
WARNING
While maintenance or adjustments are being made,
someone could start the engine. Accidental starting
of the engine could seriously injure you or other
bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance. Also push
the wire(s) aside so it does not accidentally contact
the spark plug(s).
Note: Determine the left and right sides of the machine
from the normal operating position.
Form No. 4501-494 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *4501-494* A
Printed in the USA

Advertisement

loading

Summary of Contents for Exmark 116-9360

  • Page 1 This manual uses two other words to highlight information. Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. © 2012—Exmark Mfg. Co., Inc. www.Exmark.com Original Instructions (EN) All Rights Reserved *4501-494* A Industrial Park Box 808...
  • Page 2 Loose Parts Use the chart below to verify that all parts have been shipped. Item Description Item Description Part No. Part No. 116-9285 Asm-Tensioner Arm W/Bearing 116-9280 Damper-Mule Belt Drive 109-8754 Spacer 109-6658 Nut-Nyloc 3/8-16 Flg 109-8866 Bushing, Plastic 3231-31 Bolt-Carriage 3/8-16 x 2 1/2 104-8301 3231-5...
  • Page 3 Installation Instructions 1. Make sure all moving parts have stopped, parking brake is engaged, and the key has been removed. 2. Remove and retain rear bumper and its mounting hardware. 3. Loosen the mule drive idler pulley on the right hand side of the unit so it can slide upward in the slot.
  • Page 4 assemble the bushing, spacer, and extension spring onto the tightener arm assembly as shown in Figure 2. 14. Secure the upper spring hook to the frame using 3/8-16 x 2 1/2 inch bolt, spacer, bushing, and 3/8 inch nyloc nut as shown in Figure 2. 15.