Setup - Exmark 116-8431 Operator's Manual

Setup

Installing Operator Controlled Discharge
Accessory on Mower Deck
Use a hammer and chisel to knock out either the
standard or extended tab, as shown in Figure 2,
before starting the installation instructions. Knocking
out the tab allows the Operator Controlled Discharge
accessory frame to fit properly to some decks.
Check the location of the mounting pin as shown in
Figure 2. If necessary, remove the bolt and mounting
pin and place it into the correct location. Reinstall the
bolt to secure the mounting pin.
1. Latch position for all riders
2. Latch position—not used
3. Standard knock out tab—All units except 72 inch
4. Extended knock out tab—72 inch units
5. Bolt
6. Pin location for 60 and 72 inch units
7. Pin location for all 48 and 52 inch units
8. Mounting pin
9. Break off tabs/Blocker gate trim
1. Flip up the existing discharge deflector.
Important: The Operator Controlled
Discharge accessory comes with its own
discharge deflector. When using the Operator
Controlled Discharge accessory, Exmark
recommends the original discharge deflector
to remain installed on the unit and in the
flipped up position. There are some instances
where the existing discharge deflector must
be removed when installing the Operator
Controlled Discharge accessory. If the
original discharge deflector is removed during
the Operator Controlled Discharge accessory
installation, retain the discharge deflector
Figure 2
and its hardware for reinstallation once the
Operator Controlled Discharge accessory is
removed.
1. Flip up discharge
deflector
2. Mounting pin inserted
into deck tube
2. Install the Operator Controlled Discharge
g019956
accessory assembly, by inserting the mounting
pin into the tube welded to the rear corner of the
deck (see Figure 2 for pin location).
3. Pivot the assembly towards the deck. The front
pin should engage into the slot in the deck as
shown in Figure 4.
7
Setup
Figure 3
3. Operator Controlled
Discharge accessory
assembly
4. Rotate
g020078