Setup - Exmark 135-5271 Operator's Manual

Setup

Installing Operator Controlled Discharge
Accessory on Mower Deck
For 44 inch models: Use a hammer and chisel to
knock out the standard tab, as shown in Figure 2,
before starting the installation instructions. Knocking
out the tab allows the Operator Controlled Discharge
accessory frame to fit properly to these decks.
Check the location of the mounting pin as shown in
Figure 2. If necessary, remove the bolt and mounting
pin and place it into the correct location. Reinstall the
bolt to secure the mounting pin.
1. Latch position for 32 inch models
2. Additional latch position
3. Standard knock out tab for 44 inch model
4. Extended knock out tab for 44 inch model
5. Bolt
6. Pin location for 36 inch models
7. Pin location for 32 inch models
8. Mounting pin
9. Break off tabs/Blocker gate trim
1. Install the bracket onto the right frame using the
hardware shown in Figure 3.
Figure 2
1. Bracket for 32 and 36
inch models
2. Bracket for 44 inch
model
2. Flip up the existing discharge deflector.
Important: The Operator Controlled
Discharge accessory comes with its own
discharge deflector. When using the Operator
Controlled Discharge accessory, Exmark
recommends the original discharge deflector
to remain installed on the machine and in the
flipped up position. There are some instances
where the existing discharge deflector must
g285508
be removed when installing the Operator
Controlled Discharge accessory. If the
original discharge deflector is removed during
the Operator Controlled Discharge accessory
installation, retain the discharge deflector
and its hardware for reinstallation once the
Operator Controlled Discharge accessory is
removed.
3. Install the Operator Controlled Discharge
accessory assembly.
• For 44 inch model: Insert the mounting pin
into the tube welded to the rear corner of the
deck.
7
Setup
Figure 3
3. 1/4-20 x 1 inch carriage
bolt
4. 1/4 inch nyloc flanged
nut
g285558