Skope TME Series User Manual

Skope TME Series User Manual

Vertical chiller

Advertisement

TME Series
SKOPE Vertical Chiller
TME1000

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TME Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Skope TME Series

  • Page 1 TME Series SKOPE Vertical Chiller TME1000...
  • Page 2 For pricing information on an extended warranty visit www.skope.com/warrantyprotection Service & Support We know you will get years of satisfaction from your new SKOPE product when you follow a few simple preventative maintenance guidelines.
  • Page 3: Table Of Contents

    Troubleshooting......... 11 SKOPE TME Series...
  • Page 4: Installation

    This appliance is not designed to be stable while in motion. Use  extreme caution when moving or transporting the appliance. Please contact SKOPE customer services for advice regarding disposal  of this appliance. WARNING Always disconnect the chiller from the mains power supply before attempting any cleaning or maintenance.
  • Page 5: Positioning The Chiller

    SKOPE TME Series Positioning the Chiller Power Cord The chiller has a flexible power cord fitted with a 3-pin plug, which exits below the rear sign panel. Pull the power cord around so that it’s not trapped before you position the chiller.
  • Page 6: Fitting The Illuminated Sign

    SKOPE TME Series Fitting the Illuminated Sign New Zealand models only. The illuminated sign is packed inside the chiller for transit purposes. To fit the illuminated sign 1. Loosen the four retaining screws on top of the chiller, and fit the left and right hand ventilated sign sides in position.
  • Page 7: Operation

    SKOPE TME Series Operation Start-Up After the chiller has been positioned in a suitable place, plug it in and check the following activity. Note: After moving the chiller, allow the chiller to stand for at least 30 minutes before connecting to the power supply.
  • Page 8: Servicing

    SKOPE TME Series Servicing Cleaning Ensure the chiller is disconnected from the power supply before cleaning. WARNING Twin unit chillers have two separate power supplies. Ensure both supplies are disconnected before undertaking any service or maintenance work. Cabinet Periodically wipe the inside and outside of the cabinet with a damp cloth, taking care to keep moisture away from electrical parts.
  • Page 9: Lighting

    SKOPE TME Series Lighting This chiller is designed for use with LED tubes and is not compatable with fluorescent tubes. IMPORTANT DO NOT use fluorescent tubes. Interior Light Depending on the model, the chiller will have either one or two interior lights which can be replaced without moving shelves or removing product.
  • Page 10: Sign Light

    SKOPE TME Series 4. Rotate the LED tube until the pins on the ends of the tube align with the slots, then slide it out. 5. Fit a new LED tube. Ensure the LED tube is fitted with the power end at the top (usually marked ‘POWER’...
  • Page 11: Troubleshooting

    SKOPE TME Series Troubleshooting For problems with the chiller and refrigeration unit, use the following table. Problem Possible Cause Suggestions • Chiller not operating • Loss of power • Check mains power supply. supply • Interior light not on • Failed LED tube •...
  • Page 12 E-mail: enquiry@skope.com.au Website: www.skope.com.au Trademark Infringement The SKOPE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after their state, condition, get-up or packaging has been altered in any manner •...

This manual is also suitable for:

Tme475Tme650Tme1000Tme1500

Table of Contents