Advertisement
5.
Tap the top of the 850w side panel (D) with a cushioned mallet to fully engage.
Tie the extended 3-way junction (A) to the 850w side panel (D) using a bottom
connector link (Z) as shown above (see step 2 for method).
7.
W
W
4mm Allen Key
Lower the worksurfaces (E-1) onto the brackets (Y) attached to the structure in step
6. Attach the worksurface fixing brackets (Y) to the underside of the worksurfaces
(E-1) using 1x M6x20mm socket button head machine screw (W) per bracket (Y).
Repeat this step for the opposite worksurface (E-2) .
DEN.Curve Assembly Instructions
Z
Bottom Connector Link
W
W
W
E-1
W
M6x20 Button
Den.Curve
Head Bolts
Worksurface
(x5)
6.
Y
Small Worksurface
Fixing Bracket
(x10)
100
150
100
Attach the worksurface fixing brackets (Y) to the Den structure using 1x M6x20mm
socket button head machine screw (W) per bracket (Y) in the positions shown above.
Using the top holes for a 730mm worksurface height and the bottom holes for a
750mm worksurface height (see above). When fixing the brackets to the structure,
make sure to pass the machine screws through the 7mm hole and not the slot.
8.
When the Den unit is in its final position, re-adjust the levellers as necessary to ensure
the unit is balanced. If adjusting levellers with a bottom connector link attached (Z),
make sure the nut is fully tightened up to the link (Z) after adjustment of the leveller
height.
150
100
100
W
M6x20 Button
Head Bolts
(x10)
Y
730mm Worksurface height
750mm Worksurface height
DWG No: SASS-0033
Revision: B (27/10/15)
Drawn by: JB
Drawn date: 05/12/14
Advertisement
