Table of Contents
Advertisement
Actionair SPAN Installation Guide
Inspection and handover check sheet
This certificate applies only to Swegon Fire Dampers. The installer must complete this installation certificate when instal-
ling fire and smoke dampers. A separate certificate must be completed for each individual fire and smoke damper.
Question
1
Are the dampers the correct type?
2
Are the dampers located correctly?
3
Are the dampers correctly identified?
4
Have supports for both the damper and the adjacent
ductwork been installed in accordance with the appro-
ved manner?
5
Are the dampers fitted in the correct orientation?
6
Is access through the ductwork, to the damper unob-
structed?
7
Has the space around the damper and within the
opening been left clear and not been used for other
services?
8
Using the access opening provided, check that blades
open and close.
9
Has the damper been checked for internal cleanliness,
free from damage and that vertical casings in particular
are free from debris?
10
Has the damper been released to simulate operation of
the thermal release? (Damper drop test)
11
Have the damper blades been re-set following drop
test and the access panel replaced?
12
At the time of damper handover, is the fire barrier and
penetration seal complete?
13
Is the damper installation complete and available for
handover prior to system commissioning?
14
Is the completed handover register cross-referenced
back to the identification codes listed in the system
designers damper schedule?
Damper Unique System I.D: ..........................................................................................................................................................
Name of installation location:.........................................................................................................................................................
Address:............................................................................................................................................................................................
Installation location identification section/floor/room: ................................................................................................................
Damper product type: ....................................................................................................................................................................
Release fuse temperature: ..............................................................................................................................................................
Notes/Considerations: ....................................................................................................................................................................
Installed by: .....................................................................................................................................................................................
Company Name: ............................................................................................................................................................................
Address: ..........................................................................................................................................................................................
Company Telephone No: ...............................................................................................................................................................
Installers Name: ..............................................................................................................................................................................
Installers Telephone No: .................................................................................................................................................................
Date of installation: ........................................................................................................................................................................
It is hereby verified that the damper detailed above has been installed and tested according to the manufacturers
recommendations:
Installers signature: ................................................................................................
10
Swegon reserves the right to alter specifications.
Action
Confirm damper is correct type for the application
The damper location is to be checked against the installation
drawings/details
Unique system ID to be clearly indicated on the damper or
other agreed location.
Confirm the damper is installed with any actuators (if applica-
ble) on the left or right hand side. Not on the top or the bot-
tom (i.e. blade pivot running vertically) unless permitted under
the respective DoP.
Unobstructed space should be provided for safe access to the
damper. This must include access through ceiling voids and ad-
jacent services. Damper installer to advise the system designer
if problems are foreseen.
Other services within the installation opening will invalidate
the installation method. Damper installer to advise the lead
contractor if problems are foreseen.
Check position of damper blades.
With the damper in the closed position, inspect for damage.
Ensure damper operation is free from interference.
After re-setting the damper, check the position shown on the
blade position indicator is correct.
Damper installer to record on the handover register if
any following trades are still to complete their activities.
Obtain the relevant acceptance of the damper installation from
the CDM coordinator.
20220811 - L00009 (1.2)
Date: ................................................
Advertisement
Table of Contents
