Table of Contents
Advertisement
Available languages
Available languages
EN
• Keep the drums clean. Dirt on drums will cause poor tracking and belt slippage.
• Operate tool with dust collector to keep dust from accumulating.
• The shielded ball bearings in this tool are permanently lubricated at the factory. They require no further lubrication.
Troubleshooting
Problems
Grinder won't start
Excessive vibration
Motor overheats.
Fuses are being blown or circuit
breakers are being tripped
5
Probable Cause
1. Blown line fuse or tripped circuit breaker
2. Low line voltage
3. Material wedged between wheel and guard
4. Defective switch
5. Defective, blown capacitor
1. Improper mounting of grinder or accessories
2. Grinding wheel out of balance
3. Improper wheel mounting
1. Excess pressure required to grind material
2. Grinding on side of wheel
3. Motor not turning freely (without power)
1. Overloading due to binding
2. Defective plug
3. Defective cord
4. Defective switch
5. Faulty internal wiring
WWW.BORMANNTOOLS.COM
Remedy
1. If fuse is blown, replace with fuse of proper
size. If breaker tripped, reset it
2. Check power supply for voltage and correct
as needed
3. Turn grinder off and remove material
4. Replace switch
5. Replace capacitor
1. Remount
2. Dress wheel or replace wheel
3. Rotate wheel 90° with respect to its previous
position.
1. Dress wheel or replace wheel with one of
proper grit
2. Grind only on face of wheel
3. Clean around wheel and shaft and/or replace
bearings
1. Clean around wheel and shaft and/or replace
bearings
2. Replace plug
3. Replace cord
4. Replace switch
5. Contact authorized Service Center
Advertisement
Table of Contents
