PROAIM CINEMA VCTR-TH Assembly Manual

Dual tripod holder for camera cart

Dual Tripod Holder For Camera Cart

(VCTR-TH)

A s s e m b l y M a n u a l

What's In The Box

Please inspect the contents of your shipped package to ensure you have received everything that is listed

below.

38mm (OD) Dia Mast

Accessory Cross Bar with Clamp

1 x 38mm (ID)

Tripod Holder Bar with Clamp

1 x Pair Tripod

5mm, 6mm Allen key

Clamp

Holder

No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means,

electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright

statutes or in writing by the Publisher.

Table of Contents

Need help?

Do you have a question about the CINEMA VCTR-TH and is the answer not in the manual?

Page 1 Dual Tripod Holder For Camera Cart (VCTR-TH) A s s e m b l y M a n u a l What’s In The Box Please inspect the contents of your shipped package to ensure you have received everything that is listed below.
Page 2 Tripod Holder Setup • Remove both the knobs of the 38mm (ID) clamp. • Attach the clamp to the bottom crossbar and secure it properly using both the knobs. • Image showing clamp attached to the crossbar. • Loosen the side clamp knobs of the accessory crossbar and mount the crossbar on the side rods of the cart.
Page 3 • Tighten the ratchet knob of the top accessory crossbar clamp as shown in the image. • Loosen the ratchet knob and open the clamp on the tripod holder bar. • Mount the tripod holder bar on the 38mm mast and tighten the ratchet knob. Tripod Holder Mounting •...
Page 4 • Both the tripod holders are correctly attached to the cart, as shown in the image. NOTE: Proaim Dual Tripod Holder for Camera Cart is a perfect add-on accessory to carry or store two full-size tripods on the cart. YOUR PROAIM...