Control Functions - GENMAX GM1200i User Manual

CONTROL PANEL FEATURES GM1200i
① 120-Volt, 20-Amp Duplex Outlet (NEMA 5-20R):
The outlet is capable of carrying a maximum of 20
amps.
② USB Duplex: 5V DC that come in 1 amps and2.1
amps.
③ Reset Breaker: If the inverter is overloaded, the
reset breaker will trip. The engine will continue to run,
but there will be no output from the inverter. Unplug
the devices and reduce the load. Push in the reset
breaker to reset it.
④ Efficiency Mode Switch: When turned to the ON
position, the engine will sense the load needed and
run at a slower RPM to save fuel.
⑤ Ground Terminal: The ground terminal is used to
externally ground the inverter.
⑥ Low Oil Alarm: Indicates low oil level.
⑦
Overload Alarm: Indicates that the inverter is
overloaded.
⑧ Output Indicator: Indicates the inverter is ready to
be used.
⑨ Engine Switch: Press ON to start the engine,
press OFF to turn OFF the engine.
⑩ AC Breaker: If the inverter is overloaded, the reset
breaker will trip to block current.

CONTROL FUNCTIONS

⑪ Parallel Connectors: To increase AC power output, the
connector sockets are used to connect the two same type
generator with special paralleling cords. The connector
sockets is only used to the
communication between the inverters, they can not used for
AC power output. The special paralleling cords shall be
purchase separately, and they shall be approved by
certification body.
⑫
CO Alarm: Flashing red light: dangerous levels of
carbon monoxide gas have built up leave immediately until
area has aired out. Move generator to well-ventilated area
before operation. Flashing yellow light: carbon monoxide
sensor malfunction. Sensor needs service.
8
12
10
11