Advertisement
Quick Links
Advertisement
Related Manuals for GENMAX GM6000iED
Summary of Contents for GENMAX GM6000iED
- Page 1 GM6000iED Choke stepper motor maintenance operation instructions 2022.6.9...
-
Page 2: Tool Introduction
Tool Introduction cross gun Hand tools are also available: 1. Cross screwdriver 2. Tweezers or other sharp tools 电枪... - Page 3 1 Removing the panel rear cover • Before • After 3. Throttle stepper motor connection box (if it cannot be recognized, 2.Remove disassemble the left the battery appearance cover） door 1.Turn the knob to remove the battery door; remove the 6 bolts with a cross screwdriver or stun gun.
- Page 4 2、Remove the left exterior cover • Before • After 1.Use a cross screwdriver or flathead screwdriver to remove the two bolts 2.Snap the cover down and remove the cover open choke 3.You can feel it with status your hand to adjust the position of the damper.
-
Page 5: Check Wiring
3、Check wiring • Panel box (male plug) • Stepper motor socket (female socket) 1.Check whether the wiring harness of the plug-in box is correct according to the picture 2.Observe whether the pins are loose or deformed. Red、orange、Yellow Yellow、 Orange、 Blank、Blue、Pink Pink（Black Red）、Blue、... - Page 6 4、repair 1.Use tweezers or 3.Lift up the reverse 4.Insert the wire harness 2.Pull the terminal other sharp tools to button of the into the correct position out of the socket. flatten the terminals. terminal according to the diagram in step 3, then push the terminal inward, the terminal will not come loose。...
- Page 7 5、Install • Joint the two sockets Note: When docking the socket, be careful not to insert the pins crookedly.
- Page 8 6、Install the panel rear cover • Install the panel rear cover 1.Assemble the panel back cover in place and assemble the 6 Phillips bolts. 2.Install the battery door and lock the knob in the vertical direction...
- Page 9 7、Install the left exterior cover Install the left exterior cover Assemble the cover plate in place and fasten the two Phillips bolts.
- Page 10 8、Start-CO Alarm Self-Test 2.Press the switch 3. Press the One to "ON" key start button to start 1.Turn the switch to the fuel gear and start again (after the fuel tank is refueled). 4.The CO alarm self-test flashes the yellow light once and goes out, indicating that the self-test is successful and the CO alarm is working normally.