Otto Bock 476L52 Series Instructions For Use Manual page 27

476L52=SK035 mounting kit (gooseneck, see fig. 3)
Item Article designation
1 Clamping lever for joint
Oval head screw for joint, alternative to clamping lever for joint
2 Vertical tube, straight
3 Clamping lever for clamp fitting
4 Clamp fitting
5 Clamp plate
6 Horizontal tube, with ball joint head and shaped plate
7 Tube bend
5.2 Storage
Store the product in a dry, enclosed room with sufficient air circulation and
protection from external influences. Specific information about storage con­
ditions: see Page 34.
6 Preparing the product for use
6.1 Installation
6.1.1 Installing the clamp fitting
6.1.1.1 Installation on the back support bracket
The 491L75=ST010 adapter kit is available to install the head support
mounting kit on standard seats with back support brackets:
491L75=ST010 Adapter kit (see fig. 4)
Item Description
1 Cap nut DIN 986
2 Adapter
3 Spacer washer
4 Oval head screw
1) Put the oval head screws (see fig. 4, item 4) through the bores in the
clamp fitting and adapter (see fig. 6).
2) Screw the clamp fitting and adapter to the back support bracket using
spacer washers and cap nuts (see fig. 4, item 3, 1). Insert the spacer
washers between the cap nuts and back support bracket as you do so
(see fig. 7, item 1).
Quantity
2
1
2
2
27