Advertisement
Display
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Integrated_Single/DD24SI9/User_Guide_DD24SI9/0...
Possible Cause
A7: Auto
recovery program:
Dishwasher
has detected
excess foam in
the drawer.
A09: Sanitize cycle
hasn't
met temperature needed
to sanitize dishes.
What To Do
/ ► to resume the wash program.
5. If the fault code persists, check
the filter on the inlet hose is not
blocked, and clear if needed.
If the drawer is
filled with foam
when you open
it, contact
Customer Care.
1. Let the auto recovery program run
until it is complete. The
wash program will resume when the
auto recovery program has
completed.
2. Check that you are using the
right detergent before running
another wash program.
3. If the drawer is filled with foam at the
end of the wash program, contact
Customer Care.
1. Check if the water supply has been
turned off or the wash
cycle interrupted.
2. Press ► once to stop the
beeping, and then again to clear the
fault.
3. Run the sanitize cycle again.
Updated: Thu, 02 Dec 2021 06:06:39 GMT
Powered by
7
Advertisement
