Advertisement
'A' Fault Codes
If the display is showing an 'A' fault code, follow the steps below to try and fix the issue. If the fault persists, note down
the code before disconnecting the dishwasher from the
water and power supplies and contact Customer Care.
Display
Possible Cause
Water supply fault
Drawer cannot drain. The drainage
hose may be blocked or kinked, or
the connection to drainage pipe may be
blocked.
The spray arm has loosened or come off its
mounting, or water pressure is too low.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Integrated_Single/DD24SI9/User_Guide_DD24SI9/0...
What To Do
1. Ensure the water supply is turned on.
2. Press
once to stop the beeping, and then again to clear
the fault.
3. Press
to resume the wash program.
1. Ensure the drainage hose and connection to pipes
are not blocked.
2. Press
once to stop the beeping, and then again to clear
the fault.
3. Press
to resume the wash program.
1. Open the drawer and check the spray arm.
2. If the spray arm has loosened or come off its
mounting, re-fit it. Check that it is firmly seated and
turns freely (See "User maintenance instructions").
3. Press
once to stop the beeping, and then again to clear
the fault.
4. Press
Updated: Thu, 02 Dec 2021 06:06:39 GMT
Powered by
3
Advertisement
