Advertisement
Display
Possible Cause
Auto recovery program:
Dishwasher has detected excess foam in
the drawer.
Sanitize cycle hasn't met
temperature needed to sanitize dishes.
(DD*C
Models
Only)
DD*D & DD*I Models
How Do I Know if There is a Fault?
• Your dishwasher will beep continuously and the indicators on the control panel will light up and flash.
• Note down which indicators are lit and flashing. There are two types of fault code - 'A' and 'F'. See below for which
type of code your dishwasher is displaying.
• You may be able to fix some faults yourself - see the table on following page.
• If you cannot clear the fault, contact Customer Care for support or to organize a visit by a service technician (See
'Service and warranty' booklet for contact details).
'A' Fault Codes
If only the wash modifier indicators are flashing, it is an 'A' fault.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Integrated_Single/DD24SI9/User_Guide_DD24SI9/0...
What To Do
to resume the wash program.
1. Let the auto recovery program run until it is
complete. The wash program will resume when
the auto recovery program has completed.
2. Check that you are using the right
detergent before running another wash program.
3. If the drawer is still filled with foam at the end of
the wash program, contact customer care.
1. Check if the water supply has been turned off or
the wash program interrupted.
2. Press
once to stop the beeping, and then again to clear
the fault.
3. Run the sanitize cycle again.
Updated: Thu, 02 Dec 2021 06:06:39 GMT
Powered by
4
Advertisement
