Saving Current Settings To "User1" Through "User5; Switching Input Signals - Eizo CuratOR EX4342 Installation Manual

●

Saving current settings to "User1" through "User5"

You can save the current setting values and display status to "User1" through "User5".
1.
Press MENU.
The Setting menu appears.
2.
Press F3/Down or F4/Up to select "Preferences", and then press ENTER.
The "Preferences" menu appears.
3.
Press F3/Down or F4/Up to select "PRESET Save", and then press ENTER.
The "PRESET Save" menu appears.
4.
Press F3/Down or F4/Up to select one from "User1" to "User5", and then press
ENTER.
Current setting values and display status will be saved in the selected item.

1-2. Switching Input Signals

Select the signal input to the monitor and display it on the screen.
1.
Press INPUT.
The input port menu appears.
2.
Press F3/Down or F4/Up to select an input signal.
This switches to the selected input signal.
3.
Press INPUT.
This exits the menu screen.
Note
• If you press INPUT while the input port menu is displayed in dual screen mode (PbyP or PinP), the "PbyP" / "PinP"
menu is displayed. For details, see
• After the input port menu is displayed, the input port menu will disappear after 10 seconds if no key operations
are performed.
4
Chapter 1 Basic Adjustment / Setting
"PbyP" (page 9) and "PinP" (page 10).