Otto Bock Genium X3 Information And Safety Signals page 4

Type of Event
error
e.g. service interval has
Warning
expired
Overheating of the
Hydraulic
hydraulic unit e.g. due to
system
uninterrupted, increased
overheated
activity
e.g. a sensor
(tube adapter, triple sen-
sor, ...) is not operating
Error
Selftest failure
(if signals occur after
removing the charger)
AXON Tube Adapter has
been disconnected while
the knee joint is activated
and the inductive
AXON
charger is not attached
Tube Adapter
disconnected
AXON Tube Adapter
not connected while
removing the inductive
charger
e.g. failure of the valve
drive
Critical error
Selftest failure
(if signals occur after
removing the charger)
Charging
Status 0%
No electronic
functionality
No functionality
Error code on
the display of
the Remote
Control
If assistance is required during the start-up, use or maintenance of the product, as well as in the event of
unexpected operating behaviour or circumstances, contact the Ottobock office responsible for your country.
Otto Bock Healthcare Products GmbH
Brehmstraße 16 · 1110 Wien · Austria
T +43 1 523 37 86 · F +43 1 523 22 64
info.austria@ottobock.com · www.ottobock.com
All manuals and user guides at all-guides.com
User restriction
No restriction
Reduced activity
Walking possible with
restrictions
High stance resistance
Swing phase no longer
possible
Activation of safety mode
Swing phase no longer
possible
Required action
Consult Ottobock
Allow the hydraulic unit
to cool down by reducing
activity
Restart the knee joint by
attaching and removing the
inductive charger (up to
three times);
If error remains, consult
Ottobock immediately
Connect the
AXON Tube Adapter
Restart the knee joint by
attaching and removing the
inductive charger (up to
three times);
If error remains, consult
Ottobock immediately
Charging required
Consult Ottobock
immediately
Consult Ottobock
immediately
(Error code number
required)
Last update 26.11.2014