Table of Contents
Advertisement
2
3
4
If you always use
wash be used regularly, eg every 5th wash should be at least a warm one to maintain the
cleanliness of your washer.
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of
balance load is detected, the washer will stop and re-try spinning one more time. If it still
senses an unbalanced load there are two options the washer can take.
Automatic recovery OFF (default setting)
Your washer will stop, beep, and show
screen. You must redistribute the load more evenly yourself and touch
cycle. Use this option if you wish to conserve water.
34
CHANGING PRE-SET OPTIONS
or
COLD
CONTROLLED COLD
Select
wash temperature by touching
COLD
the
button (if not already
WASH TEMP
selected).
The digital display shows the temperature
adjustment possible. The default setting is
, ie the temperature of the incoming
water from the cold water supply.
Touch
until
MORE
washer will now control the cold temperature
to approximately 20°C.
Each of the remaining settings equals an
approximate 1°C temperature increase or
decrease from this point.
water, we recommend that a
in three phases on the display
is displayed. Your
or
WARM
HOT
to resume the
Advertisement
Table of Contents
