I Call Channel Programming; I Channel Comments - Icom IC-M602 Instruction Manual

I Call channel programming

The call channel is used to select Channel 9, however, you
can program your most often-used channels in each channel
group for quick recall.
q While pushing [H/L], push [CH/WX•U/I/C] one or more
times to select the desired channel group (U.S.A., Interna-
tional, Canada) to be programmed.
w Push [16•9] for 1 sec. to select the call channel of the se-
lected channel group.
• " " and call channel number appear.
e Push [16•9] again for 3 sec. (until a long beep changes to
2 short beeps) to enter call
channel programming con-
dition.
• Channel number starts blink-
ing.
r Rotate [CHANNEL] to se-
lect the desired channel.
t Push [16•9] to program the
displayed channel as the
call channel.
• Push [CH/WX•U/I/C] to can-
cel.
• The channel number stops
blinking.

I Channel comments

Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (
and space can be used.
q Select the desired memory channel.
• Cancel dual watch, tri-watch or scan in advance.
w While pushing [H/L], push [16•9] to edit the channel com-
ment.
• A cursor appears and blinks.
e Push the appropriate key several times to enter the de-
sired character.
• See the table on page 12 for available characters.
• Rotate [CHANNEL] or push [Y]/[Z] on the microphone to move
the cursor.
r Push [ENT] to input and set the comment.
• Push [CLR] to cancel.
• The cursor disappears.
t Repeat steps q to r to program other channel com-
ments, if desired.
3
BASIC OPERATION
3
)
11