Icom IC-M602 Instruction Manual page 31

D D Transmitting Group call
The Group call function allows you to transmit a DSC signal
to a specific group only.
q Push [MENU] to enter the DSC menu.
w Rotate [CHANNEL] to select "
[ENT].
e Rotate [CHANNEL] to select the desired pre-programmed
group address or "
• The ID code for the group call can be set in advance. (p. 33)
• When " " is selected, set the 8-digit ID code for
the group you wish to call with keypad.
r Rotate [CHANNEL] to select a desired intership channel
t Push [ENT] to transmit the group call.
," push
y After the group call has been transmitted, the following in-
," push [ENT].
u Push [CLR] to exit the condition.
or " ," push [ENT].
• When " " is selected, rotate [CHANNEL] to se-
lect the desired channel other than Channel 70.
• If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
dication is displayed.
6
DSC OPERATION
6
25