I Setting Tag Channels; I Starting A Scan - Icom IC-M602 Instruction Manual

I Setting tag channels

For more efficient scanning, add desired channels as tag
channels or clear tag channels for unwanted channels. Chan-
nels set as non-tag channels will be skipped during scanning.
Tag channels can be assigned to each channel group
(U.S.A., International, Canada) independently.
q While pushing [H/L], push [CH/WX•U/I/C] one or more
times to select the desired channel group, if desired.
w Select the desired channel to set as a tag channel.
e Push [F], then push [5
TAG
as a tag channel.
• " " appears in the display.
r To cancel the tag channel setting, repeat step e.
• " " disappears.
• Clearing all tag channels in the selected channel group
➥ While pushing [H/L], push [5
channels in the channel group.
[Example]: Starting a normal scan.
] to set the displayed channel
] for 3 sec. to clear all tag
TAG
Scan starts.
Push
then
4
SCN
GHI

I Starting a scan

Set scan type (priority or normal scan) and scan resume timer
in advance using set mode. (p. 45)
q Set tag channels as described at left.
w Make sure the squelch is closed to start a scan.
e While pushing [H/L], push [CH/WX•U/I/C] one or more
times to select the desired channel group, if desired.
r Push [F], then push [4
SCN
• " " or "
display.
• When a signal is detected, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to set mode set-
ting. (Channel 16 is still monitored during priority scan.)
• Rotate [CHANNEL] to check the scanning tag channels, to
change the scanning direction or resume the scan manually.
• " " blinks and a beep tone sounds when a signal is received
on Channel 16 during priority scan.
t To stop the scan, push [CLR] or repeat step r.
When a signal is received
SCAN OPERATION
] to start priority or normal scan.
" appears in the function
5
5
17