Option oe, rw, rx
Fig. 66
Further information
136
10
Maintenance
10.4
Compressor Maintenance
Draining the cooling oil (closed floor pan - stationary machine)
Oil separator tank
1
Oil filler plug
2
Oil cooler
3
Shut-off ball valve
4/5
I – open
0 – closed
➤ Remove the plug
from the oil separator tank filling port.
2
Draining the oil from the separator tank
1. Position a receptacle beneath the oil drainage point for the oil separator tank's cooling oil
2. Unscrew the corresponding screwed sealing cap at the cooling oil drain.
3. Open the shut-off valve
4. Close the shut-off valve and replace the screwed sealing cap.
Draining the oil from the oil cooler
1. Position a receptacle beneath the oil drainage point for the oil cooler's cooling oil
2. Unscrew the corresponding screwed sealing cap at the cooling oil drain.
3. Open the shut-off valve
4. Close the shut-off valve and replace the screwed sealing cap.
Perform final work steps:
1. Replace the plug
in the oil separator tank filling port.
2
2. Close the door.
Dispose of used oil and oil-contaminated working materials according to environmental pro‐
tection regulations.
See chapter 10.4.2 for oil filling.
Operator Manual
Screw Compressor
M100
6
7
8
at the oil separator tank and catch any draining cooling oil.
5
at the oil cooler and catch any draining cooling oil.
4
Screwed sealing cap - cooling oil drain
Oil cooler drain
Oil separator tank drain
.
8
.
7
No.: 9_6999 23 USE