Drilling In Metal; Troubleshooting - Porter-Cable PC600D-CA Instruction Manual

clear chips from the flutes.

dRIllING IN MetAl

Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass
which should be drilled dry. The cutting lubricants that work best are sulfurized cutting
oil or lard oil.
dRIllING IN MASoNRy
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the
drill but not so much that you crack the brittle material. A smooth, even flow of dust
indicates the proper drilling rate.
Problem
• Unit will not start.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
MAXIMuM RecoMMeNded cAPAcItIeS
CHUCK CAPACITY
R.P.M.
BITS, METAL DRILLING
WOOD, FLAT BORING
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Replacement Parts
Use only identical replacement parts. For a parts list or to order parts, visit our service website
at www.portercable.com. You can also order parts from your nearest PORTER-CABLE Factory
Service Center or PORTER-CABLE Authorized Warranty Service Center. Or, you can call our
Customer Care Center at (888) 848-5175.
Service and Repairs
All quality tools will eventually require servicing and/or replacement of parts. For information
about PORTER-CABLE, its factory service centers or authorized warranty service centers, visit
our website at www.portercable.com or call our Customer Care Center at (888) 848-5175.
All repairs made by our service centers are fully guaranteed against defective material and
workmanship. We cannot guarantee repairs made or attempted by others.

tRouBleSHootING

Possible cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
3/8 in. (9.5 mm)
0–2500
1/2 in. (13 mm) low speed
1-1/4 in. (32 mm)
7
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a PORTER-CABLE service
center or authorized servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a
PORTER-CABLE service center
or authorized servicer.)
• Have cord or switch replaced
at a PORTER-CABLE Service
Center or Authorized Servicer.