Table of Contents
Advertisement
FIT THE TRIM BRACKET
We recommend fitting the trim bracket when installing your DishDrawer™ Dishwasher into a
18 7/8" (480mm) cavity to conceal any visible gap left between the countertop and chassis.
1
2
Align the bracket to the chassis ensuring
the arrow is facing forward and firmly
slot the tabs into place to secure.
Ensure the ends of the tabs are not
pushed into the chassis.
Check the trim seal is facing forward
and sitting flat under the bracket.
PREPARE EXTERNAL VENTING
FIT THE VENTING HOSE TO THE DISHDRAWER™ DISHWASHER
1
elbow
2
TRIM THE DUCT
Framed cabinetry only
1
2
Rotate the elbow at the rear of the
product to either the left or right
depending on your venting location.
Push the vent hose onto the elbow
firmly to secure.
Unscrew the top cover from the vent
and set aside.
On a protected surface, carefully cut
and remove the clips from the vent as
shown. Refit the top cover.
15
Advertisement
Table of Contents
