235. Lid Lock Short Circuit; 241. Function Time Out; 249. Pump Time Out Fault (No Change In Water Level); 254. Motor Control Version - Fisher & Paykel CleanSmart WL8060P1 Service Diagnostic Manual

235. Lid Lock Short Circuit

Lid Lock fault, not activated when instructed to by the Motor Control Module.
Primary Source: Lid Lock mechanism has jammed or failed.
Action:
Check resistance across the connections, this should be 63 ohms +/- 10% @ 20 °C. If faulty,
replace the Lid Lock assembly.

241. Function Time Out

A fault has occurred with the Display Module.
Primary Source: Display Module has failed.
Action:
Replace Display Module.
Secondary Source: Motor Control Module has failed.
Action:
Replace Motor Control Module.

249. Pump Time Out Fault (No change in water level)

While draining, the water level reading from the pressure sensor has not changed for 3 minutes.
This fault will generally be caused by a problem with the pump or diverter valve system, either a
blockage or restriction. This will also flag if the machine is by-passing.
Primary Source: Pump system.
Action:
1) Check that the drain hose is not kinked
2) Check the length of the drain hose. A 1-metre extension hose of the same diameter fitted to the
existing drain hose is the maximum allowable length.
3) Check that the machine is not pumping to a head that exceeds the pump's
limits (1.5 meters is maximum head height).
4) Remove the inner bowl and check that there is not excessive lint or clothing in and around the
bottom of the sump restricting water flow into the pump.
5) Remove the pump and check for obstruction.
Secondary Source: Diverter valve.
Action:
Check that the diverter valve is working and replace if necessary.
Tertiary Source: Motor Controller module.
Action:
Replace the Motor Controller module.

254. Motor Control Version

The Motor Control Module software version is too old for the display to support.
Primary Source: Motor Control Module
Replace Motor Control Module
26