Suds Lock 04; Insufficient Hot Water 05; Insufficient Cold Water 06; Agitate Over Load 07 - Fisher & Paykel CleanSmart WL8060P1 Service Diagnostic Manual

Suds lock 04

Possible causes:
• Too much detergent generally causes this. If so, dissolve the suds by flushing water through the
machine and re-test.
• The pump is partially blocked, or the drain hose is kinked.
• A garment or foreign object is restricting the movement of the inner bowl.
• The main bearings are tight.

Insufficient hot water 05

Possible causes:
• The hot water is not connected or the tap is turned off.
• The flow rate is too low. The product requires a minimum flow rate of 6 litres per minute.
• The hot water temperature is too low. The water temperature needs to be 60˚C for a hot wash.
• The hot water inlet hose is connected to the cold water supply.
• That there are kinks in the inlet hose.
• The filter in the hot inlet hose at the tap end is blocked.
• The filter screen in the hot inlet valve of the machine is blocked.
• Thermistor resistance is out of range. Resistance is 10kΩ @ 25 ˚C. Replace if well outside of this
range.
•
Note: If the machine is set to controlled cold, hot water may be required to achieve the set temperature
of 20 ˚C.

Insufficient cold water 06

Possible causes:
• The cold water is not connected or the tap is turned off.
• The flow rate is too low. The product requires a minimum flow rate of 6 litres per minute.
• The cold water inlet hose is connected to the hot water supply.
• There are kinks in the inlet hoses.
• The filter on the cold inlet hose at the tap end is blocked.
• The filter screen in the cold inlet valve of the machine is blocked.
• Thermistor resistance is out of range. Resistance is 10kΩ @ 25 oC. Replace if well outside of this
range.

Agitate over load 07

Possible causes:
• The product is overloaded.
• The user has selected the wrong water level.
• The inner bowl assembly is jammed to the agitator with a foreign object that may be caught under
the agitator skirt.
• The spline drive and driven teeth are locked together with dirt, detergent or lint.
• The spline drive and driven teeth are damaged / broken.

Lid lock failure 08

Possible causes:
• The tang on the lid is bent or broken.
• The lid-lock assembly has failed. If the lid is closed and the tang is ok, replace the lid-lock assembly.
15