Table of Contents
Advertisement
Turn on the water and check all hose connections for leaks. Make sure there are no kinks in
z
the hose(s). Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
z
Test cycle
Your washer must be correctly installed before use. To check the installation and operation of
the washer follow the steps below:
1
2
3
COMPLETE INSTALLATION
Press
to activate your washer.
POWER
Select a
cycle. Ensure the drum is
QUICK
empty and the door closed.
Press
to start.
4
5
Utility
Utility
Spin
Spin
Utility
6
Spin
If there are any problems, you must address these before proceeding with normal use. The
washer will automatically turn off at the end of the cycle if there are no problems.
A test cycle must be carried out anytime the washer is moved or tipped, this will ensure
the washer has been correctly re-installed.
Wait until you see water in the bottom of
the drum.
Press
to stop the cycle, then press
to turn the washer off.
POWER
Activate the washer again by pressing
, press
or
to select
ADJUST
SPIN
and
to confirm.
Press
to begin the spin.
Check the drain hose is firmly secured to the
standpipe or tub, or spigot.
Observe that the washer pumps out the
water, and spins.
The washer will beep to signal the end of
the cycle. Any faults will be displayed on the
screen, refer your user guide.
POWER
cycle
9
Advertisement
Table of Contents
