Making A Pocket Cut - ALDI FERREX 704518 User Manual

NOTE: Do not remove the saw from the work piece while the blade is
moving.
NOTE: Since blade thickness varies, always make a trial cut in scrap material
along the guideline to determine how much, if any, the guideline must be
offset to get an accurate cut.
45 0
o o
H

Making a pocket cut

1. Adjust the depth of cut as required per previous instructions
2. Adjust the bevel setting to 0°.
3. Raise the lower blade guard lever (9) to expose the saw blade and firmly
rest the front of the base flat against the work piece with the rear handle
raised so the blade does not touch the work piece (Fig. K).
4. With the blade just clearing the work piece, start the motor by depressing
lock off button (13) and squeezing the on/off trigger (12).
5. Always let the blade reach full speed (approximately 2 seconds) before
you begin to cut into the work piece.
6. Slowly lower the circular saw into the work piece, using the front of the
base resting on the work piece as a hinge point.
WARNING! As soon as the blade starts cutting the material,
release the lower blade guard lever (9).
7. Once the base plate is flat against the work piece, proceed cutting in a
forward direction to the end of the cut.
8. After completing your cut, release the on/off trigger (12) and allow the
blade to come to a complete stop.
Do not remove the circular saw from the work piece while the blade is
moving.
AFTER SALES SUPPORT
1300 889 028
(toll free)
I
MODEL No.: PSC1856.A • 02/2021 • 704518
1200W Circular Saw
J
e-mail: info.aldi@positecgroup.com
16