Table of Contents
Advertisement
member of Group
TAILPLANE & ELEVATORS
-
Elevators:
Adjust the elevator shaft axis so the lever points points downwards at a 90 degree angle to the
fuselage centerline, then attach the movable left part of the elevator (-09) to the tailplane (-08), which is
attached with a piece of 0.7mm-1mm wire. Reinforce the whole elevator shaft (-15 & -16) by inserting the
hexagonal axle (-14) into the elevator (-09). When you are happy the assembly is correct and the elevator
moves freely, remove the hexagonal axle (-14), apply glue to the end and
re-insert through the elevator shaft (-15 & -16) into the elevator (-09). Make sure the elevator and
tailplane are level and the servo cable lever is 90 degrees to the centerline whilst the glue sets. Glue the
right part of the tailplane (-11)..
8
Advertisement
Table of Contents
