Landing Gear - 3DLab GANG PRINT BEAT MACCHI MC.200 User Manual

LANDING GEAR

Steel Wire: You will need steel wire of 3mm diameter
Retract Pins:Retract Pins from Hobby King of 3mm diameter
Landing Gear: Glue the fork (-77) to the undercarriage leg (-75) , and glue the wire of 3mm diameter into
to the hole in the leg and glue part (-76) (Repeat the process for the right side (79-80-81))
Note: If you are not using longer steel wire for gear, be very careful when completing parts 75 & 76. they
must be glued very perfectly
mm
Steel Wire: Bend the wire as per attached template.
Retract Pins: If you use the HobbyKing Retract Pins, first fix it in
the hole in Servoless retract system, and glue the leg to the pin
after.
24
member of Group