Table of Contents
Advertisement
FIN & RUDDER
Rudder:Glue the rudder part
(19) to the fuselage part (-6)
Rudder: Now to the last part of the fuselage (-7) you have to glue the control mechanism for the tail
landing gear and rudder. NOTE: it is recommended to thouroughly clean the parts and do a test fit
before applying glue Insert the rudder shaft parts with lever (-22&-23) into the part (-7) then insert the
hexagonal axle (-25) into the hexagonal top hole and through the bottom hole Then glue the
hexagonal axle to the rudder shaft parts (-22&-23). Fix the rudder shaft assembly into the fuselage (-
07) by glueing the „cap" (-26) to the top of the hexagonal axle (-25). Make sure the rudder shaft
assembly moves freely.
-
Rudder: Insert the rudder bowden servo cable
into the fusleage and full through to attach to
the rudder shaft lever (-22 & -23). Attach the
rear fuselage part (-07) to the rest of the rest of
the fuselage, making sure the rudder shaft lever
is 90 degrees to the fuselage centerline,
10
member of Group
Advertisement
Table of Contents
