3DLab GANG PRINT BEAT MACCHI MC.200 User Manual page 8

member of Group
TAILPLANE & ELEVATORS
-
Elevators: A ach the bowden servo cable to the lever on the elevator sha (-15 & -16). Insert the elevator
sha (-15 & -16) into rear of the fuselage (-6) and at the same me thread the bowden servo cable into
the right tunnel that leads to the front of the fuselage. Make sure sure side marked 'L' on the sha is to
the le viewed from the rear and the servo cable lever is poin ng down. Par ally insert the hexagonal axel
(-14) through the elevator sha (-15 & -16).
7